Home › Engine / Hybrid System › 2TR-FE (STARTING) › STARTER (for 2.0 kW Type)
RM27T0E _51 Engine / Hybrid System _053691 2TR-FE STARTING _0260714 STARTER(for 2.0 kW Type) A

2TR-FE STARTING  STARTER(for 2.0 kW Type)  REASSEMBLY  


PROCEDURE

Hide 28160 1.INSTALL STARTER ARMATURE ASSEMBLY

a.

Install the starter armature to the starter yoke.


Hide 28140 2.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.

Install the brush holder.


b.

Connect the 4 brushes to the starter brush holder.

i.

Using a screwdriver, hold back the spring.


ii.

Connect the brush to the brush holder.

NOTICE:

Check that the positive (+) lead wires are not grounded




c.

Install a new O-ring to the groove of the commutator end frame.


d.

Install the commutator end frame with the 2 screws.

Torque:
3.8 N*m (39 kgf*cm, 34 in.*lbf)


Hide 28150 3.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.

Apply high temperature grease to the idle gear, steel ball, return spring, clutch roller and retainer.


b.
A222255

Insert the steel ball into the starter clutch hole.


c.

Insert the return spring into the starter clutch hole.


d.

Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.


e.

Install the starter drive housing to the magnet starter switch with the 2 bolts.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


Hide 28120 4.INSTALL STARTER YOKE ASSEMBLY

a.

Install a new O-ring to the groove of the starter yoke.


b.
P013095E07
0.615,1.688 1.24,2.042 1.24,2.042 1.333,2.042 true 2.781,1.51 2.25,1.729 2.25,1.729 2.104,1.729 true 1.948,1.646 2.146,1.813 0.198,0.167 10 false *1 1.365,1.969 1.542,2.115 0.177,0.146 10 false *2

Align the claw of the starter yoke with the groove of the starter switch.

Text in Illustration
*1 Claw
*2 Groove


c.

Install the starter yoke to the magnet starter switch with the 2 through bolts.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


d.

Connect the lead wire to terminal C with the nut.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)