Home › Engine / Hybrid System › 5L-E (STARTING) › STARTER
RM27T0E _51 Engine / Hybrid System _053693 5L-E STARTING _0260723 STARTER A

5L-E STARTING  STARTER  REASSEMBLY  


PROCEDURE

Hide 28160 1.INSTALL STARTER ARMATURE ASSEMBLY

a.
P004699

Using a press, install the starter armature assembly.


Hide 28140 2.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.
ST00096E09
1.979,1.792 1.875,1.792 1.875,1.792 1.667,1.49 false 1.656,1.385 2.385,0.313 2.385,0.313 2.49,0.313 false 2.563,0.208 2.75,0.354 0.188,0.146 10 false *1 2.01,1.698 2.177,1.865 0.167,0.167 10 false *2

Align the claw of the brush holder with the claw groove of the starter yoke.

Text in Illustration
*1 Claw
*2 Groove


b.

Place the brush holder on the starter yoke.


c.

Connect the 4 brushes to the starter brush holder.

i.

Using a screwdriver, hold back the brush spring.


ii.

Connect the brush to the starter brush holder.

NOTICE:

Check that the positive (+) lead wires are not grounded.




Hide 28150 3.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.

Apply high-temperature grease to the starter idle pinion, starter clutch, starter armature pinion, retainer and clutch roller.


b.
A222255

Insert the steel ball into the starter clutch hole.


c.

Insert the return spring into the starter clutch hole.


d.

Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.


e.

Install the starter housing to the magnet starter switch with the 2 screws.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


Hide 28120 4.INSTALL STARTER YOKE ASSEMBLY

a.

Install a new O-ring to the groove of the starter yoke.


b.
A222271E02
0.646,0.986 0.828,1.147 0.182,0.161 10 *2 2.587,0.802 2.769,0.963 0.182,0.161 10 *1 2.145,1.202 2.491,0.898 2.491,0.898 2.578,0.898 false 1.215,0.848 0.982,1.083 0.982,1.083 0.861,1.083 false

Align the claw of the starter brush holder with the grooves of the magnet starter switch.

Text in Illustration
*1 Claw
*2 Groove


c.

Install the 2 new O-rings to the bolts.


d.

Install the 2 bolts.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


e.

Connect the terminal C wire with the nut.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


f.

Install the terminal 50 wire with the screw.

Torque:
3.6 N*m (37 kgf*cm, 32 in.*lbf)