Home › Engine / Hybrid System › 1GD-FTV (STARTING) › GLOW PLUG CONTROLLER › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0260740 GLOW PLUG CONTROLLER A

1GD-FTV STARTING  GLOW PLUG CONTROLLER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See pageGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 76622D 3.REMOVE FRONT FENDER MUDGUARD LH

Hide 53806 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 28551 5.REMOVE GLOW PLUG CONTROLLER

A246625

a.

Disconnect the 4 connectors and clamp.


b.

Remove the 2 nuts and glow plug controller from the vehicle.


Hide 28559 6.REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.


Hide 28559A 7.REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 2 glow plug controller bracket from the glow plug controller.