Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (for 2.7 kW Type)
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0260743 STARTER(for 2.7 kW Type) A

1GD-FTV STARTING  STARTER(for 2.7 kW Type)  REASSEMBLY  


PROCEDURE

Hide 28160 1.INSTALL STARTER ARMATURE ASSEMBLY

a.

Install the starter armature assembly to the starter yoke assembly.


Hide 28140 2.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.

Install the starter brush holder assembly to the starter yoke assembly.


b.

Install the 4 brushes to the starter brush holder assembly.

i.

Using a screwdriver, pull back the brush spring.


ii.

Install the brush to the starter brush holder assembly.

NOTICE:

Check that the positive (+) lead wires are not grounded.




c.

Install the commutator end frame with the 2 screws.

Torque:
3.6 N*m (37 kgf*cm, 32 in.*lbf)


Hide 28011 3.INSTALL STARTER CLUTCH SUB-ASSEMBLY

a.

Apply high-temperature grease to the idle gear, steel ball, return spring, clutch roller and retainer.


b.
A197147

Install the steel ball into the hole of starter clutch sub-assembly.


c.

Insert the return spring into the hole of starter clutch sub-assembly.


d.

Install the starter clutch sub-assembly, idle gear, retainer and clutch roller to the starter drive housing assembly.


Hide 28150 4.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.

Install the magnet starter switch assembly to the starter drive housing assembly with the 3 screws.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


Hide 28120 5.INSTALL STARTER YOKE ASSEMBLY

a.

Install the felt washer to the starter armature assembly.


b.
A197145E04
2.813,1.417 2.948,0.865 2.948,0.865 3.094,0.865 true 0.615,1.583 1.219,1.938 1.219,1.938 1.354,1.938 true 3.146,0.792 3.365,0.99 0.219,0.198 10 false *a 1.417,1.854 1.635,2.052 0.219,0.198 10 false *b

Align the protrusion of the starter yoke assembly with the groove of the magnet starter switch assembly, and install the starter yoke assembly together with the starter armature assembly.

Text in Illustration
*a Protrusion
*b Groove


c.

Install 2 bolts.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


d.

Connect the lead wire to terminal C with the nut.

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)