Send vehicle speed signal to brake actuator assembly, and then it is sent to ECM.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0122 | While ignition switch to ON, communication stop between brake actuator and ECM continues for 1 second or more | ·
Brake actuator assembly ·
CAN communication system ·
ECM |
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Check the DTCs. (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC U0122 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD with Entry and Start System) | B |
| NG (for LHD without Entry and Start System) | C |
| NG (for RHD with Entry and Start System) | D |
| NG (for RHD without Entry and Start System) | E |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
D
E