Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the driving support ECU.

WIRING DIAGRAM

E178435E04
5.262,2.178 5.641,2.334 0.379,0.156 10 G119 5.365,1.498 5.835,1.654 0.471,0.156 10 GND 5.365,0.461 5.835,0.617 0.471,0.156 10 B 5.059,1.4 5.234,1.556 0.176,0.156 10 25 5.059,0.363 5.234,0.519 0.176,0.156 10 30 5.262,2.345 6.596,2.501 1.334,0.156 10 Driving Support ECU 2.659,0.298 3.578,0.443 0.919,0.145 10 ECU-IG NO. 1 0.381,0.449 1.755,0.595 1.373,0.147 10 from IG1 NO. 1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU - BATTERY AND BODY GROUND)
a.
U170590E01
0.14,0.053 0.300,0.209 0.159,0.156 10 *a 1.518,0.47 1.878,0.609 0.360,0.140 10 G119 1.78,1.305 2.003,1.767 false 1.314,1.305 1.091,1.767 false 0.904,1.774 1.233,1.930 0.330,0.156 10 GND 1.946,1.774 2.064,1.930 0.118,0.156 10 B

Disconnect the G119 ECU connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G119-30 (B) - Body ground Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G119-25 (GND) - Body ground Always Below 1 Ω



Text in Illustration
*a Front view of wire harness connector
(to Driving Support ECU)


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR