Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM D

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  INITIALIZATION  


INITIALIZATION RELATED TO DYNAMIC RADAR CRUISE CONTROL SYSTEM


a.

Turn the ignition switch to ON.


b.

Turn the cruise control switch on.


c.

With the brake pedal depressed, push the cruise control switch to +RES 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.

NOTICE:
·

Do not turn the light control switch on at this time as doing so causes the beam axis to deviate. If the light control switch is turned on by mistake, readjust the beam axis (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).

·

If initialization cannot be performed, first inspect the stop light switch circuit, cruise control switch circuit and skid control buzzer circuit.




d.

Turn the ignition switch off.