Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0122  Lost Communication with Vehicle Dynamics Control Module  U0123  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U1104  Lost Communication with Driving Support ECU  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
U0100 While the ignition switch is ON, a communication stop between the ECM and skid control ECU or driving support ECU continues for 1 second or more.
·

Hydraulic brake booster assembly (Skid control ECU)

·

CAN communication system

·

Driving support ECU

·

ECM


U0122 While the ignition switch is ON, a communication stop between the skid control ECU and driving support ECU continues for 1 second or more.
·

ECM

·

CAN communication system

·

Hydraulic brake booster assembly (Skid control ECU)


U0123 While the ignition switch is ON, a communication stop between the yaw rate sensor and driving support ECU continues for 1 second or more.
·

Yaw rate sensor

·

CAN communication system

·

ECM


U0126 While the ignition switch is ON, a communication stop between the steering angle sensor and driving support ECU continues for 1 second or more.
·

Steering angle sensor

·

CAN communication system

·

ECM


U1104 While the ignition switch is ON, a communication stop between the driving support ECU and ECM continues for 1 second or more.
·

ECM

·

CAN communication system

·

Driving support ECU



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Select "Bus Check" from the "System Select" screen on the intelligent tester.


b.

Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".

Result
Result Proceed to
CAN DTC is not output A
CAN DTC is output (for LHD with Entry and Start System) B
CAN DTC is output (for LHD without Entry and Start System) C
CAN DTC is output (for RHD with Entry and Start System) D
CAN DTC is output (for RHD without Entry and Start System) E



A

B

C

D

E