Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1572  Improper Aiming of Radar Sensor Beam Axis  


DESCRIPTION

When the millimeter wave radar sensor beam axis has deviated, the ECM detects this and stores DTC P1572.

DTC Code DTC Detection Condition Trouble Area
P1572 While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on and the millimeter wave radar sensor performing self diagnosis, axis deviation is detected for 1 second. Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the millimeter wave radar sensor assembly beam axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).


PROCEDURE

1.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
a.

Adjust the millimeter wave radar sensor assembly (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (31 mph) or more.


ii.

Turn the cruise control switch on.



c.


OK

END

NG

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY