Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Millimeter Wave Radar Sensor Power Source Circuit  


DESCRIPTION

This circuit provides power to the millimeter wave radar sensor. The millimeter wave radar sensor emits radar waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front.

WIRING DIAGRAM

E178425E04
4.512,2.178 5.134,2.329 0.622,0.151 10 A15 5.075,1.512 5.546,1.668 0.471,0.156 10 SGND 5.075,0.475 5.546,0.631 0.471,0.156 10 IGB 4.809,1.39 4.918,1.546 0.110,0.156 10 2 4.809,0.335 4.919,0.490 0.110,0.156 10 5 4.512,2.345 7.073,2.487 2.561,0.142 10 Millimeter Wave Radar Sensor Assembly 2.49,0.289 3.412,0.427 0.922,0.138 10 ECU-IG NO. 1 0.075,0.466 1.449,0.613 1.373,0.147 10 from IG1 NO. 1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR - BATTERY AND BODY GROUND)
NOTICE:

A DTC is stored when the following inspection is performed. Be sure to clear the DTC after performing this inspection.


a.
U170589E01
0.446,0.15 0.617,0.308 0.171,0.158 10 *a 1.58,0.347 1.846,0.496 0.266,0.150 10 A15 2.196,1.743 2.466,1.899 0.270,0.156 10 IGB 0.977,1.743 1.410,1.899 0.434,0.156 10 SGND 1.999,1.202 2.336,1.739 false 1.584,1.202 1.248,1.739 false

Disconnect the A15 sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A15-5 (IGB) - Body ground Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A15-2 (SGND) - Body ground Always Below 1 Ω



Text in Illustration
*a Front view of wire harness connector
(to Millimeter Wave Radar Sensor Assembly)


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR