Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER (for RHD)
RM27T0E _52 Drivetrain _053699 CLUTCH _0260795 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  INSTALLATION  


PROCEDURE

Hide 31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

except 1GD-FTV:

i.

Install a new gasket.



b.

for 1GD-FTV:

i.

Install a new gasket and clutch master cylinder bracket.



c.

Install the clutch master cylinder with the 2 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


d.
U170068E01
0.42,1.911 0.621,2.088 0.201,0.177 10 *1

Apply MP grease to the contact surfaces of the pin and clevis bush.

Text in Illustration
*1 MP grease


e.

Connect the clevis to the clutch pedal with the pin.


f.

Install a new clip to the pin.


Hide 31481 2.CONNECT FLEXIBLE HOSE TUBE

a.

Using a union nut wrench, connect the flexible hose tube.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 31464 3.INSTALL CLUTCH MASTER CYLINDER HEAT INSULATOR (for 1GD-FTV)

a.

Install the clutch master cylinder heat insulator with the 2 nuts.

Torque:
15 N*m (50 kgf*cm, 43 ft.*lbf)


Hide 4.FILL RESERVOIR WITH BRAKE FLUID

Hide 6.CHECK FLUID LEVEL IN RESERVOIR

Hide 7.CHECK FOR BRAKE FLUID LEAK FROM CLUTCH LINE

Hide 31301 8.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY