Home › Drivetrain › CLUTCH › CLUTCH ACCUMULATOR
RM27T0E _52 Drivetrain _053699 CLUTCH _0260800 CLUTCH ACCUMULATOR A

CLUTCH  CLUTCH ACCUMULATOR  INSTALLATION  


PROCEDURE

Hide 31490 1.INSTALL CLUTCH ACCUMULATOR ASSEMBLY

a.

for 1GR-FE:

i.

Install the clutch accumulator with the 3 bolts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


ii.

Using a union nut wrench, connect the clutch release cylinder to flexible tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



iii.

Install the nut.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


iv.

Install the clutch release cylinder to accumulator tube (See page Drivetrain>CLUTCH>CLUTCH RELEASE CYLINDER (for 1GR-FE)>INSTALLATION).



b.

except 1GR-FE and 1GD-FTV:

i.

Install the clutch accumulator with the 3 nuts.

Torque:
5.0 N*m (50 kgf*cm, 44 in.*lbf)


ii.

Using a union nut wrench, connect the accumulator to flexible hose tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



iii.

Using a union nut wrench, connect the clutch master cylinder to flexible hose tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

for 1GD-FTV:

i.

Install the clutch accumulator with the 3 nuts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


ii.

Install the clip and connect the flexible hose tube.


iii.

Using a union nut wrench, install the accumulator to flexible hose tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)



iv.

Using a union nut wrench, connect the clutch master cylinder to accumulator.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 31121 2.INSTALL NO. 1 CLUTCH HOUSING COVER (for 1GR-FE)

Hide 37140 3.INSTALL FRONT PROPELLER SHAFT ASSEMBLY (for 1GR-FE)

Hide 4.FILL RESERVOIR WITH BRAKE FLUID

Hide 6.CHECK FLUID LEVEL IN RESERVOIR

Hide 7.CHECK FOR CLUTCH FLUID LEAK