31250
1.INSPECT CLUTCH DISC ASSEMBLY
When replacing the clutch disc assembly, make sure to perform an inspection of the flywheel sub-assembly and clutch cover assembly.
Using a vernier caliper, measure the rivet depth.
0.3 mm (0.0118 in.)
If the depth is less than the minimum, replace the clutch disc assembly.
Using a dial gauge, measure the clutch disc assembly runout.
0.7 mm (0.0276 in.)
If the runout is more than the maximum, replace the clutch disc assembly.
31210
2.INSPECT CLUTCH COVER ASSEMBLY
Using a vernier caliper, measure the depth and width of the diaphragm spring wear.
| Depth | Width |
|---|---|
| 0.35 mm (0.0138 in.) | 5.0 mm (0.197 in.) |
| *a | Width |
| *b | Depth |
If the depth or width is more than the maximum, replace the clutch cover assembly.
Perform a visual inspection of the clutch cover assembly.
Inspect for hair cracks or scratches extending from the center outwards, or discoloration.
Inspect for hair cracks in a circular pattern, discoloration or excessive wear.
| *a | Hair cracks, scratches or discoloration |
| *b | Hair cracks, discoloration or excessive wear |
If there is any damage, replace the clutch cover assembly.
13405
3.INSPECT FLYWHEEL SUB-ASSEMBLY
Using a dial gauge, check the flywheel sub-assembly runout.
0.1 mm (0.00393 in.)
If the runout is more than the maximum, replace the flywheel sub-assembly.
Perform a visual inspection of the flywheel sub-assembly.
Inspect for hair cracks or scratches extending from the center outwards, or discoloration.
Inspect for hair cracks in a circular pattern, discoloration or excessive wear.
| *a | Hair cracks, scratches or discoloration |
| *b | Hair cracks, discoloration or excessive wear |
If there is any damage, replace the flywheel sub-assembly.
31230
4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY
Check that the clutch release bearing moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing (contact surfaces with the clutch cover) while applying force in the axial direction.
Inspect the clutch release bearing for damage or wear.
If necessary, replace the release bearing assembly.