84520
1.INSPECT CLUTCH START SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | On (Pushed) | Below 1 Ω |
| 1 - 2 | Off (Not pushed) | 10 kΩ or higher |
| *a | Component without harness connected
(Clutch Start Switch Assembly) |
| *b | On: 7.65 to 8.35 mm (0.302 to 0.328 in.) |
| *c | Off: 1.65 to 2.35 mm (0.0650 to 0.0925 in.) |
If the result is not as specified, replace the clutch start switch assembly.