55936E
1.INSPECT CENTER CLUSTER MODULE SWITCH (TRANSFER POSITION SWITCH)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 16 (LO) - 24 (E) | H4 | 10 kΩ or higher |
| L4 | Below 1 Ω |
| *a | Component without harness connected
(Center Cluster Module Switch (Transfer Position Switch)) |
If the result is not as specified, replace the center cluster module switch (transfer position switch).
Apply battery voltage between the terminals of the switch, and check the illumination condition of the center cluster module switch (transfer position switch).
| Measurement Condition | Switch Condition |
|---|---|
| Battery positive (+) → 13 (ILL+) Battery negative (-) → 12 (ILL-) | Illuminates |
| *a | Component without harness connected
(Center Cluster Module Switch (Transfer Position Switch)) |
| *b | Center Cluster Module Switch (Transfer Position Switch) Illumination |
If the result is not as specified, replace the center cluster module switch (transfer position switch).