Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM27T0E _52 Drivetrain _053704 DRIVE SHAFT / PROPELLER SHAFT _0260852 PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SLEEVE YOKE SUB-ASSEMBLY

a.
G022296E10
1.219,0.208 1.448,0.354 0.229,0.146 9 false *a

Place matchmarks on the propeller shaft and sleeve yoke.

Text in Illustration
*a Matchmark


b.

Remove the sleeve yoke from the propeller shaft.


Hide 2.REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

HINT:

Use the same procedure for all rear propeller shaft universal joint spider bearing.


a.
F015023E18
1.844,0.958 2.323,0.292 2.323,0.292 1.979,0.99 false 2.344,0.219 2.594,0.385 0.25,0.167 10 false *1

Place matchmarks on the flange yoke and sleeve yoke.

Text in Illustration
*a Matchmark


b.
C061264

Using a brass bar and hammer, slightly tap in the spider bearing outer races.


c.

Using 2 screwdrivers, remove the 4 snap rings from the grooves.


d.
F015025E27
0.438,1.021 1.167,0.948 false 2.208,1.479 2.51,1.188 false 0.094,0.938 0.406,1.167 0.313,0.229 10 true SST 1.948,1.385 2.177,1.563 0.229,0.177 10 true (A)

Using SST, remove the spider bearing from the sleeve yoke.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.



e.
F044192E19
2.333,0.719 2.948,1.313 false 2.875,1.323 3.104,1.583 0.229,0.26 10 false *a

Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

Text in Illustration
*a Hammering Point

HINT:

Remove the spider bearing on the opposite side using the same procedure.


NOTICE:

Do not tap the shaft.



f.
F015030E23
0.479,1.188 0.938,1.083 false 1.74,0.781 2.531,1.042 false 0.104,1.104 0.406,1.271 0.302,0.167 10 false SST 1.479,0.677 1.708,0.844 0.229,0.167 10 false (A)

Install the 2 removed spider bearing outer races to the universal joint spider.


g.

Using SST, remove the bearing from the yoke.

SST
09332-25010  

HINT:

Sufficiently raise the part labeled by A so that it does not come into contact with the bearing.



h.
F044193E18
2.448,0.573 1.646,0.26 false 1.438,0.146 1.667,0.354 0.229,0.208 10 false *a

Clamp the outer bearing race in a vise between aluminum plates and tap off the yoke with a hammer.

Text in Illustration
*a Hammering Point


i.

Remove the universal joint spider.