Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM27T0E _53 Suspension _053709 REAR SUSPENSION _0260895 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48540 1.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension)

a.

Install the cushion No. 2 to the rear shock absorber assembly LH.


b.
C214690

C214691

Install the cushion No. 1 and rear shock absorber assembly LH with a new nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

Be sure to fit the positioning protrusion of the bracket into the hole in the frame.



c.
D028132

Temporarily install the rear shock absorber assembly LH with the bolt.


d.

Connect the absorber control actuator connector.


Hide 48540 2.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)

a.

Install the cushion No. 2 to the rear shock absorber assembly LH.


b.
D028133

Temporarily install the cushion No. 1 and rear shock absorber assembly LH with a new nut.


c.
D028132

Temporarily install the rear shock absorber assembly LH with the bolt.


d.

Tighten the nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 3.INSTALL REAR WHEEL

Torque:
for Aluminum Wheel : 103 N*m (1050 kgf*cm, 76 ft.*lbf)
for Steel Wheel : 112 N*m (1137 kgf*cm, 82 ft.*lbf)

Hide 4.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Bounce the vehicle up and down several times to stabilize the suspension.


Hide 48540 5.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the bolt.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)