Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2015.06–2017.08
RM27T0E _53 Suspension _053710 TIRE PRESSURE MONITORING _0260907 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


a.

Disconnect the tire pressure warning ECU and receiver R41 connector and measure the voltage or resistance on the wire harness side.

U148932E01
0.181,0.115 0.477,0.325 0.296,0.210 10 *a 2.52,0.863 2.883,1.026 0.363,0.163 10 R41

Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R41-1 (IG) - R41-12 (GND) G - BR IG power source Ignition switch ON 10 to 16 V
R41-12 (GND) - Body ground BR - Body ground Ground Always Below 1 Ω


b.

Connect the tire pressure warning ECU and receiver R41 connector.


c.

Measure the voltage according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

HINT:

Inspect the connectors from the back side while the connectors are connected.


U149179E01
0.121,0.089 0.417,0.299 0.296,0.210 10 *a 2.253,0.865 2.616,1.028 0.363,0.163 10 R41

Text in Illustration
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R41-7 (CLSW) - R41-12 (GND) P - BR Tire pressure warning reset switch
·

Ignition switch ON

·

Tire pressure warning reset switch ON


Below 1.5 V
·

Ignition switch ON

·

Tire pressure warning reset switch OFF


8 to 15 V