Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2015.06–2017.08
RM27T0E _53 Suspension _053710 TIRE PRESSURE MONITORING _0260907 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TC and CG Terminal Circuit  


DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are output by the blinking of the tire pressure warning light.

WIRING DIAGRAM

C171960E13
5.177,1.875 6.875,2.25 1.698,0.375 10 false Tire Pressure Warning ECU and Receiver 5.531,0.531 5.656,0.698 0.125,0.167 10 false 3 5.771,0.708 6.063,0.885 0.292,0.177 10 false TC 0.781,1.802 1.146,1.979 0.365,0.177 10 false G48 0.781,1.99 1.302,2.177 0.521,0.188 10 false DLC3 1.188,0.688 1.5,0.885 0.313,0.198 10 false TC 1.146,1.292 1.396,1.51 0.25,0.219 10 false CG 1.49,0.583 1.688,0.76 0.198,0.177 10 false 13 1.521,1.156 1.729,1.333 0.208,0.177 10 false 4 5.177,1.698 5.531,1.906 0.354,0.208 10 false R41

HINT:

When each warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND)
a.

Disconnect the tire pressure warning ECU and receiver R41 connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G48-13 (TC) - R41-3 (TC) Always Below 1 Ω
G48-13 (TC) or R41-3 (TC) - Body ground Always 10 kΩ or higher
G48-4 (CG) - Body ground Always Below 1 Ω




OK

CHECK PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU