Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) › 2015.06–2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260911 VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster)  CHECK FOR INTERMITTENT PROBLEMS  


DESCRIPTION


HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected through the ECU data monitor function of the intelligent tester.


a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


f.

Select areas where momentary interruptions should be monitored.

HINT:
·

A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).

·

If Error is displayed, check for continuity between the ECUs and the sensors or between ECUs.

·

Error remains displayed on the intelligent tester for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal.



ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
FR Speed Open Front speed sensor RH open circuit detection/
Error or Normal
Normal -
FL Speed Open Front speed sensor LH open circuit detection/
Error or Normal
Normal -
RR Speed Open Rear speed sensor RH open circuit detection/
Error or Normal
Normal -
RL Speed Open Rear speed sensor LH open circuit detection/
Error or Normal
Normal -
EFI Communication Open ECM communication open circuit detection/
Error or Normal
Normal -
Yaw Rate Open Yaw rate and acceleration sensor open circuit detection/
Error or Normal
Normal -
Deceleration Open Deceleration sensor open circuit detection/
Error or Normal
Normal -
Steering Open Steering angle sensor open circuit detection/
Error or Normal
Normal -
Master Cylinder Open Master cylinder pressure sensor open circuit detection/
Error or Normal
Normal -
IG Voltage Value Decreased IG1 voltage value decreased detection/
Error or Normal
Normal -
IG Voltage Value Increased IG1 voltage value increased detection/
Error or Normal
Normal -
FR Speed Sensor Voltage Open Front speed sensor RH voltage open circuit detection/
Error or Normal
Normal -
FL Speed Sensor Voltage Open Front speed sensor LH voltage open circuit detection/
Error or Normal
Normal -
RR Speed Sensor Voltage Open Rear speed sensor RH voltage open circuit detection/
Error or Normal
Normal -
RL Speed Sensor Voltage Open Rear speed sensor LH voltage open circuit detection/
Error or Normal
Normal -
M/C Pressure Sensor Noise Master cylinder pressure sensor noise detection/
Error or Normal
Normal -
Yaw Rate Sensor Voltage Open Yaw rate and acceleration sensor voltage open circuit detection/
Error or Normal
Normal -
EFI Communication Invalid ECM communication invalid detection/
Error or Normal
Normal -


g.

While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors or between ECUs.

OK:

Normal display appears.


NOTICE:

The connector and/or wire harness has a momentary interruption (open circuit) if the display changes. Repair or replace the connectors and/or wire harnesses as one of them is faulty.