Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR › 2015.06–2016.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260913 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Other than areas where instructions are provided, use the same procedures for the RH and LH sides.



PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR

a.

Install the speed sensor with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

·

While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

·

After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

·

Make sure there is no foreign matter attached to the speed sensor rotor.




Hide 2.INSTALL SKID CONTROL SENSOR CLAMP

a.

Install the skid control sensor clamp with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:

Install the clamp so that the rotation stopper touches the knuckle.



Hide 89516 3.INSTALL FRONT SKID CONTROL SENSOR WIRE

a.

Connect the connector as follows.

i.

for LH:

1. Attach the connector, and then connect the connector.

NOTICE:

Securely connect the connector.



ii.

for RH:

1. Install the skid control sensor clamp with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

NOTICE:

Make sure the clamp rotation stopper touches the installation position.


2. Attach the connector, and then connect the connector.

NOTICE:
·

Securely connect the connector.

·

When connecting the connector, do not twist the wire harness.



3. Attach the clip.



b.

Install the 2 harness clamps with the 2 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:
·

When installing the clamps, do not twist the wire harness.

·

Make sure the clamp rotation stopper touches the installation position.




c.

Install the 2 harness clamps with the 2 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:
·

When installing the clamps, do not twist the wire harness.

·

Make sure the clamp rotation stopper touches the installation position.




d.

Attach the clip.


e.

Connect the connector.

NOTICE:

Securely connect the connector.



Hide 42603 4.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 103 N*m (1050 kgf*cm, 76 ft.*lbf)
for Steel Wheel : 112 N*m (1137 kgf*cm, 82 ft.*lbf)

Hide 89543 5.CHECK SPEED SENSOR SIGNAL