Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER › 2015.06–2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260917 SKID CONTROL BUZZER A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  SKID CONTROL BUZZER  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 2.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 86652A 3.REMOVE SKID CONTROL BUZZER ASSEMBLY

a.
C212852E01
0.067,0.424 0.303,0.608 0.236,0.184 12 *A 0.05,2.883 0.288,3.066 0.238,0.184 12 *B

Detach the clamp and remove the buzzer.

Text in Illustration
*A for LHD
*B for RHD


b.

Disconnect the connector.