84970D
1.INSPECT CRAWL CONTROL SWITCH
Measure the resistance according to the value(s) in the table below.
| *a | LO |
| *b | LO / MEDIUM |
| *c | MEDIUM |
| *d | MEDIUM / HI |
| *e | HI |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 17 (ECU) - 24 (E) | LO | Below 1 Ω |
| 18 (UP) - 24 (E) | ||
| 19 (DN) - 24 (E) | 10 kΩ or higher | |
| 17 (ECU) - 24 (E) | LO / MEDIUM | Below 1 Ω |
| 18 (UP) - 24 (E) | 10 kΩ or higher | |
| 19 (DN) - 24 (E) | ||
| 17 (ECU) - 24 (E) | MEDIUM | 10 kΩ or higher |
| 18 (UP) - 24 (E) | ||
| 19 (DN) - 24 (E) | ||
| 17 (ECU) - 24 (E) | MEDIUM / HI | 10 kΩ or higher |
| 18 (UP) - 24 (E) | ||
| 19 (DN) - 24 (E) | Below 1 Ω | |
| 17 (ECU) - 24 (E) | HI | 10 kΩ or higher |
| 18 (UP) - 24 (E) | Below 1 Ω | |
| 19 (DN) - 24 (E) | ||
| 21 (FRB) - 24 (E) | ON/OFF: Pressed | Below 1 Ω |
| ON/OFF: Not pressed | 10 kΩ or higher |
| *a | Component without harness connected
(Center Cluster Module switch (Crawl Control Switch)) |
If the result is not as specified, replace the crawl control switch.