1.INSPECT MULTI-TERRAIN SELECT SWITCH
Measure the resistance according to the value(s) in the table below.
| *a | MUD & SAND |
| *b | LOOSE ROCK |
| *c | MOGUL |
| *d | ROCK & DIRT |
| *e | ROCK |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 17 (ECU) - 24 (E) | MUD & SAND | Below 1 Ω |
| 18 (UP) - 24 (E) | ||
| 19 (DN) - 24 (E) | 10 kΩ or higher | |
| 17 (ECU) - 24 (E) | LOOSE ROCK | Below 1 Ω |
| 18 (UP) - 24 (E) | 10 kΩ or higher | |
| 19 (DN) - 24 (E) | ||
| 17 (ECU) - 24 (E) | MOGUL | 10 kΩ or higher |
| 18 (UP) - 24 (E) | ||
| 19 (DN) - 24 (E) | ||
| 17 (ECU) - 24 (E) | ROCK & DIRT | 10 kΩ or higher |
| 18 (UP) - 24 (E) | ||
| 19 (DN) - 24 (E) | Below 1 Ω | |
| 17 (ECU) - 24 (E) | ROCK | 10 kΩ or higher |
| 18 (UP) - 24 (E) | Below 1 Ω | |
| 19 (DN) - 24 (E) | ||
| 20 (FRE) - 24 (E) | ON/OFF: Pressed | Below 1 Ω |
| ON/OFF: Not pressed | 10 kΩ or higher |
| *a | Component without harness connected
(Center Cluster Module Switch (Multi-terrain Select Switch)) |
If the result is not as specified, replace the center cluster module switch (multi-terrain select switch).