Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 1KD-FTV) › 2015.06–2020.08
RM27T0E _54 Brake _053713 BRAKE SYSTEM (OTHER) _0260934 VACUUM PUMP(for 1KD-FTV) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1KD-FTV)  REASSEMBLY  


PROCEDURE

Hide 29300 1.INSTALL VACUUM PUMP BEARING

C111354

a.

Using a press, press in a new bearing to the shaft.


Hide 29336 2.INSTALL VACUUM PUMP SHAFT

C111355E01
0.491,0.608 0.815,0.773 0.324,0.166 10 SST 1.5,0.694 0.86,0.694 false

a.

Using SST and a press, press in the shaft to the housing.

SST
09608-04031  


b.

Using snap ring pliers, install a new snap ring.

NOTICE:

Make sure that the snap ring is firmly installed to the groove.



Hide 29351 3.INSTALL VACUUM PUMP GEAR

a.

Install the woodruff key and gear to the pump with the gear lock nut.


b.

Mount the gear in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the gear.



c.

Tighten the gear lock nut.

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)


Hide 29331 4.INSTALL VACUUM PUMP BLADE

C111356E02
0.374,0.139 0.567,0.323 0.193,0.184 10 *a

a.

Apply engine oil to the rotor and install the rotor to the housing.


b.

Install 5 new blades with the round end facing outward.

Text in Illustration
*a Round End

HINT:
·

Apply engine oil to the blade.

·

Make sure that the blades are flush with the rotor surface.




Hide 5.INSTALL VACUUM PUMP END COVER

a.

Mount the pump in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the pump.



b.

Install 2 new O-rings.


c.

Install the end cover and temporarily install the 3 bolts.


d.

Using a 5 mm pin punch and hammer, tap in the 2 straight pins.


e.

Tighten the 3 bolts.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)


Hide 29369 6.INSTALL CHECK VALVE SUB-ASSEMBLY

a.

Install a new gasket and the check valve.

Torque:
74 N*m (755 kgf*cm, 54 ft.*lbf)


b.

Install 2 new gaskets and the union with the union bolt.

Torque:
14 N*m (140 kgf*cm, 10 ft.*lbf)

HINT:

Align and insert the union pin into the matching hole of the casing.