Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE
RM27T0E _54 Brake _053714 BRAKE (FRONT) _0260936 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 47313A 1.INSTALL FRONT FLEXIBLE HOSE

a.

Using a union nut wrench, connect the brake tube to the front flexible hose while holding the front flexible hose with a wrench to install the front flexible hose.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




b.

Install 2 new clips to the front flexible hose.


Hide 2.BLEED BRAKE LINE (for Hydraulic Brake Booster)

Hide 42603 4.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 103 N*m (1050 kgf*cm, 76 ft.*lbf)
for Steel Wheel : 112 N*m (1137 kgf*cm, 82 ft.*lbf)