Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM27T0E _54 Brake _053714 BRAKE (FRONT) _0260937 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43512 1.INSTALL FRONT DISC

a.

Align the matchmarks and install the front disc.

HINT:

When replacing the disc with a new one, select the installation position where the disc has the smallest runout.



Hide 47750 2.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

a.

Install the disc brake cylinder assembly with the 2 bolts.

Torque:
185 N*m (1886 kgf*cm, 136 ft.*lbf)


b.

Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 04945 3.INSTALL FRONT NO. 1 ANTI SQUEAL SHIM

NOTICE:

If necessary, replace the anti-squeal shim when replacing the brake pad.


a.

Install the front No. 1 anti-squeal shims to the front disc brake pads.

NOTICE:

There should be no oil or grease on the friction surfaces of the front disc brake pads and the front disc.



Hide 04465 4.INSTALL FRONT DISC BRAKE PAD

a.

Install the 2 front disc brake pads to the disc brake cylinder.


b.

Install the anti-rattle spring between the 2 front disc brake pads.

NOTICE:

The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.



c.

Install the 2 hole pins.


d.

Install the pin hold clip.

NOTICE:

The pin hold clip can be reused if has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.



Hide 5.BLEED BRAKE LINE (for Hydraulic Brake Booster)

Hide 7.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 103 N*m (1050 kgf*cm, 76 ft.*lbf)
for Steel Wheel : 112 N*m (1137 kgf*cm, 82 ft.*lbf)