Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
Wash the brake fluid off immediately if it adheres to any painted surfaces.
47319F
3.DISCONNECT REAR FLEXIBLE HOSE LH
Remove the union bolt and gasket from the rear disc brake cylinder, and then disconnect the rear flexible hose from the rear disc brake cylinder.
Use a container to catch brake fluid as it drains out.
47750A
4.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH
Remove the 2 cylinder slide pins from the rear disc brake cylinder.
Remove the rear disc brake cylinder from the rear disc brake cylinder mounting.
04466
5.REMOVE REAR DISC BRAKE PAD
Remove the 2 rear disc brake pads together with the rear disc brake anti-squeal shims from the rear disc brake cylinder mounting.
47744C
6.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM
Remove the 2 rear disc brake anti-squeal shims from each rear disc brake pads.
47771A
7.REMOVE REAR DISC BRAKE PAD WEAR INDICATOR PLATE
Remove the rear disc brake pad wear indicator plate from the inner disc brake pad.
47716A
8.REMOVE REAR NO. 1 DISC BRAKE PAD SUPPORT PLATE
If it is necessary to remove the pad support plates, replace them with new ones.
Remove the 2 pad support plates from the rear disc brake cylinder mounting.
47717A
9.REMOVE REAR NO. 2 DISC BRAKE PAD SUPPORT PLATE
If it is necessary to remove the pad support plates, replace them with new ones.
Remove the 2 pad support plates from the rear disc brake cylinder mounting.
47722A
10.REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH
Remove the 2 bolts, 2 plate washers and rear disc brake cylinder mounting.
47775D
11.REMOVE REAR DISC BRAKE BUSH DUST BOOT
Remove the rear disc brake bush dust boot from the rear disc brake cylinder mounting.
47769A
12.REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH
Remove the rear disc brake cylinder slide bush from the rear disc brake cylinder mounting.
47713A
13.REMOVE REAR DISC BRAKE CYLINDER HOLE PLUG
Remove the rear disc brake cylinder hole plug from the rear disc brake cylinder mounting.
42431
14.REMOVE REAR DISC
Put matchmarks on the rear disc and axle hub if planning to reuse the disc.
| *1 | Matchmark |
Turn the shoe adjuster until the disc turns freely, and then remove the disc.
|
Shoe Adjuster Contracts |
|
Shoe Adjuster Expands |