The power steering ECU receives signals from the ECM, steering angle sensor and skid control ECU via the CAN communication system.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | The engine speed signal is lost. | ·
ECM ·
CAN communication system ·
Power steering ECU assembly |
| U0126 | The steering angle signal is lost. | ·
Steering angle sensor (Spiral cable sub-assembly) ·
CAN communication system ·
Power steering ECU assembly |
| U0129 | The vehicle speed signal is lost. | ·
Skid control ECU ·
CAN communication system ·
Power steering ECU assembly |
Clear the DTC(s) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM (w/ VSC)>DTC CHECK / CLEAR).
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM (w/ VSC)>DTC CHECK / CLEAR).
| Result | Proceed to | |
|---|---|---|
| DTC is not output. | A | |
| DTC is output. | for LHD with Entry and Start System | B |
| for LHD without Entry and Start System | C | |
| for RHD with Entry and Start System | D | |
| for RHD without Entry and Start System | E | |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
D
E