Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GR-FE)
RM27T0E _55 Steering _053717 POWER ASSIST SYSTEMS _0260946 VANE PUMP(for 1GR-FE) G

POWER ASSIST SYSTEMS  VANE PUMP(for 1GR-FE)  INSPECTION  


PROCEDURE

Hide 1.INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP FRONT HOUSING

a.
C132029E11
2.938,0.302 2.792,0.302 2.792,0.302 2.573,1.042 false 0.427,1.083 0.635,1.281 0.208,0.198 10 false *a 2.99,0.229 3.198,0.427 0.208,0.198 10 false *b

Using a micrometer, measure the outer diameter of the vane pump shaft.

Text in Illustration
*a Outer Diameter
*b Inner Diameter


b.

Using a vernier caliper, measure the inner diameter of the vane pump front housing bush.


c.

Calculate the oil clearance.

Oil clearance = Inner diameter of the bush - Outer diameter of the shaft

Maximum oil clearance:

0.07 mm (0.00276 in.)


If the oil clearance is more than the maximum, replace the vane pump assembly.


Hide 2.INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE

a.
C101977E11
2.469,0.333 3.167,0.573 0.698,0.24 10 false *a

Using a micrometer, measure the thickness of the vane pump plates.

Standard thickness:

1.405 to 1.411 mm (0.0554 to 0.0555 in.)

Text in Illustration
*a Thickness


If the thickness is not as specified, replace the vane pump assembly.


b.
C101978E02
0.905,0.046 1.800,0.220 0.895,0.174 10 *1 1.133,0.13 1.414,0.13 1.414,0.13 1.524,0.239 false

Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane pump plate.

Maximum clearance:

0.025 mm (0.00098 in.)

Text in Illustration
*1 Feeler Gauge


If the clearance is more than the maximum, replace the vane pump assembly.


Hide 3.INSPECT PRESSURE PORT UNION

If the union seat in the pressure port union is severely damaged, it may cause fluid leakage. In that case, replace the vane pump assembly.