1.CHECK DRIVE BELT TENSION
Visually check the belt for cracks, oiliness or wear. Check that the belt does not touch the bottom of the pulley groove.
If necessary, replace the belt.
| *a | Clearance |
| *b | Correct |
| *c | Incorrect |
Check the drive belt deflection by pressing on the belt at the point indicated in the illustration with 98 N (10 kgf, 22 lbf) of force.
| *a | Crankshaft Pulley |
| *b | Vane Pump Pulley |
|
Measuring Point for Belt Deflection |
| Item | Specified Condition |
|---|---|
| New belt | 8.0 to 10 mm
(0.315 to 0.393 in.) |
| Used belt | 10 to 15 mm
(0.394 to 0.590 in.) |
If necessary, adjust the drive belt deflection.
Using a belt tension gauge, check the drive belt tension.
| Item | Specified Condition |
|---|---|
| New belt | 441 to 539 N
(45 to 55 kgf, 99.2 to 121 lbf) |
| Used belt | 196 to 343 N
(20 to 35 kgf, 44.1 to 77.1 lbf) |
If the belt tension is not as specified, adjust it.