1.INSPECT VANE PUMP SHAFT AND BUSH IN FRONT VANE PUMP HOUSING
Using a micrometer, measure the outer diameter of the vane pump shaft.
| *a | Outer Diameter |
| *b | Inner Diameter |
Using a vernier caliper, measure the inner diameter of the vane pump front housing bush.
Calculate the oil clearance.
Oil clearance = Inner diameter of the bush - Outer diameter of the shaft
0.07 mm (0.00276 in.)
If the oil clearance is more than the maximum, replace the vane pump assembly.
2.INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE
Using a micrometer, measure the thickness of the vane pump plates.
| *a | Thickness |
1.405 to 1.411 mm (0.0554 to 0.0555 in.)
If the thickness is not as specified, replace the vane pump assembly.
Using a feeler gauge, measure the clearance between the side of the vane pump rotor groove and the vane pump plates.
| *1 | Feeler Gauge |
0.025 mm (0.00098 in.)
If the clearance is more than the maximum, replace the vane pump assembly.