Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM › 2015.06–2017.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260954 STEERING LOCK SYSTEM U

STEERING COLUMN  STEERING LOCK SYSTEM  TERMINALS OF ECU  


CHECK STEERING LOCK ECU


U169877E02
1.594,0.115 1.885,0.26 0.292,0.146 10 false G35

a.

Disconnect the G35 steering lock ECU connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G35-1 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω
G35-6 (IG2) - G35-1 (GND) W - W-B IG2 signal input Engine switch off → engine switch on (IG) Below 1 V → 11 to 14 V
G35-7 (B) - G35-1 (GND) G - W-B Power source Always 11 to 14 V

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the G35 steering lock ECU connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G35-3 (IGE) - G35-1 (GND) W - W-B Power source for motor drive When all conditions are met:
·

Steering lock unlocked

·

Engine switch off

·

Shift lever in P*

·

Driver side door closed → opened


11 to 14 V (Steering lock motor not operating) → Below 1 V (Steering lock motor operating) → 11 to 14 V (Steering lock motor not operating)
G35-4 (SLP1) - G35-1 (GND) SB - W-B Unlock position sensor output signal Steering lock locked → steering lock unlocked 11 to 14 V → Below 1.2 V

*: for Automatic Transmission

If the result is not as specified, there may be a malfunction in the steering lock ECU.