Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM › 2015.06–2017.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260955 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM D

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG) and check the freeze frame data by following the prompts on the intelligent tester screen.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Tilt Position Current tilt position data/min.: 0, max.: 65535 28672 to 36864 -
Telesco Position Current telescopic position data/min.: 0, max.: 65535 28672 to 36864 -
Tilt Return Position Memorized tilt return position data/min.: 0, max.: 65535 28672 to 36864 -
Telesco Return Position Memorized telescopic return position data/min.: 0, max.: 65535 28672 to 36864 -
Tilt Up Switch Input state of tilt up by manual switch/ON or OFF ON: Tilt up activated by manual switch
OFF: Tilt up not activated by manual switch
-
Tilt Up SW(CAN) Input state of tilt up by manual switch/ON or OFF ON: Tilt up activated by manual switch
OFF: Tilt up not activated by manual switch
-
Tilt Down Switch Input state of tilt down by manual switch/ON or OFF ON: Tilt down activated by manual switch
OFF: Tilt down not activated by manual switch
-
Tilt Down SW(CAN) Input state of tilt down by manual switch/ON or OFF ON: Tilt down activated by manual switch
OFF: Tilt down not activated by manual switch
-
Telesco Short Switch Input state of telescopic short by manual switch/ON or OFF ON: Telescopic short activated by manual switch
OFF: Telescopic short not activated by manual switch
-
Telesco Short SW(CAN) Input state of telescopic short by manual switch/ON or OFF ON: Telescopic short activated by manual switch
OFF: Telescopic short not activated by manual switch
-
Telesco Long Switch Input state of telescopic long by manual switch/ON or OFF ON: Telescopic long activated by manual switch
OFF: Telescopic long not activated by manual switch
-
Telesco Long SW(CAN) Input state of telescopic long by manual switch/ON or OFF ON: Telescopic long activated by manual switch
OFF: Telescopic long not activated by manual switch
-
T&T Manual SW Data Voltage data of manual switch/min.: 0.00 V, max.: 4.99 V Neutral position: Below 0.2 V
Tilt up: 1.67 to 2.13 V
Tilt down: 0.54 to 0.74 V
Telescopic contract: 1.08 to 1.40 V
Telescopic extend: 2.22 to 2.77 V
-
Power Source Voltage Voltage data of power supply/min.: 0.00 V, max.: 19.99 V 11 to 14 V -
Freeze Speed Info Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) Actual vehicle speed -
IG Switch (CAN) Communication state of engine switch/ON or OFF ON: Communication normal
OFF: Communication interrupted
-
IG Switch Input state of engine switch/ON or OFF ON: Input signal normal
OFF: Input signal interrupted
-
Receive from Meter Communication state of combination meter signal/OK or Interpt OK: Communication normal
Interpt: Communication interrupted
-
Receive from Seat ECU Communication state of position control ECU signal/OK or Interpt OK: Communication normal
Interpt: Communication interrupted
-
Receive from Combi Communication state of combination switch ECU signal/OK or Interpt OK: Communication normal
Interpt: Communication interrupted
-
J/B Communication state of main body ECU signal/OK or Interpt OK: Communication normal
Interpt: Communication interrupted
-
Handle Position Steering wheel position signal/Away or Return Away: Steering wheel in away position
Return: Steering wheel in return position
(Except remote start)
-
The Number of DTCs Number of stored diagnostic trouble codes/min.: 0, max.: 255 Actual number of stored diagnostic trouble codes -