Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)
RM27T0E _55 Steering _053718 STEERING COLUMN _0260957 STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column)  REASSEMBLY  


PROCEDURE

Hide 82291D 1.INSTALL KEY INTERLOCK SOLENOID WIRE (w/o Entry and Start System)

a.

Install the key interlock solenoid wire on to the install the ignition switch.


Hide 84450 2.INSTALL IGNITION SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C128812

Install the ignition switch onto the steering column upper bracket with the 2 screws.


Hide 85432 3.INSTALL KEY INTERLOCK SOLENOID (w/o Entry and Start System for Automatic trans mission)

a.
C128811

Install the key interlock solenoid onto the steering column upper bracket with the 2 screws.


b.

Connect the connector.


Hide 84052 4.INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C128815

Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.

HINT:

Slide the unlock warning switch in the direction shown by the arrow in the illustration to install it.



Hide 69057A 5.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

a.

Turn the ignition switch to ON (ACC).


b.
C128816

Install the ignition switch lock cylinder into the steering column upper bracket.


c.

Make sure that the ignition switch lock cylinder is securely fixed onto the ignition switch lock cylinder.


Hide 6.INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)

a.
C128817

Remove the key and check that the steering lock function is activated.


b.
C128818

Insert the key, turn the ignition switch ON (ACC) and check that the steering lock function is deactivated.


Hide 45020A 7.INSTALL STEERING LOCK ACTUATOR ASSEMBLY

HINT:

When replacing the steering lock actuator assembly, refer to the Service Bulletin.


a.

Temporarily install the steering lock actuator assembly with a new tapered-head bolt.


b.
C215854E01
1.203,0.013 1.587,0.278 0.384,0.265 12 *A 1.203,2.421 1.587,2.686 0.384,0.265 12 *B

Tighten the tapered-head bolt until the bolt head breaks off.

Text in Illustration
*A w/o Entry and Start System
*B w/ Entry and Start System