Home › Steering › STEERING COLUMN › TILT AND TELESCOPIC MANUAL SWITCH › 2015.06–2020.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260961 TILT AND TELESCOPIC MANUAL SWITCH A

STEERING COLUMN  TILT AND TELESCOPIC MANUAL SWITCH  INSTALLATION  


PROCEDURE

Hide 89235A 1.INSTALL TILT AND TELESCOPIC SWITCH

a.

Attach the claw to install the tilt and telescopic switch.


b.

Connect the connector.


Hide 45287 2.INSTALL STEERING COLUMN LOWER COVER

a.

Install the 3 screws.


b.

Attach the 2 claws to install the steering column lower cover.

NOTICE:

Do not damage the tilt and telescopic switch.



Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
·

Reset the auto tilt away function setting to the previous condition by changing the customize parameter (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).