Home › Steering › STEERING COLUMN › HEATED STEERING WHEEL SYSTEM
RM27T0E _55 Steering _053718 STEERING COLUMN _0260963 HEATED STEERING WHEEL SYSTEM U

STEERING COLUMN  HEATED STEERING WHEEL SYSTEM  TERMINALS OF ECU  


CHECK HEATED STEERING WHEEL CONTROLLER


HINT:

Inspect the connectors from the back side while the connectors are connected.


U111172E09
4.615,0.521 4.771,0.698 0.156,0.177 10 false A 2.021,0.396 2.177,0.573 0.156,0.177 10 false B

a.

Measure the voltage or resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
A-1 (CCU) - Body ground LED output signal Engine switch on (IG), Steering heater switch on Below 3 V
A-2 (CCV) - Body ground Steering heater switch input signal Engine switch on (IG), Steering heater switch pressed and held 11 to 14 V
A-3 (CCX) - Body ground Ground Always Below 1 Ω
A-4 (CCW) - Body ground IG power supply Engine switch on (IG) 11 to 14 V
B-1 (TH1) - Body ground Thermistor input signal Engine switch on (IG), Steering heater switch on at 0 to 40°C (32 to 104°F) 1.5 to 4.5 V*1
B-2 (TH2) - Body ground Thermistor ground Engine switch on (IG), Steering heater switch on Below 1 V
B-3 (SH2) - Body ground Heater output signal Engine switch on (IG), Steering heater switch on 11 to 14 V*2
B-4 (SH1) - Body ground Heater ground Engine switch on (IG), Steering heater switch on Below 1 V

HINT:
·

*1: When ambient temperature is 0 to 40°C (32 to 104°F).

·

*2: The current to the heater turns ON/OFF depending on the temperature of the thermistor. As a result, it may take several minutes before a voltage value is output.