45503
1.INSTALL STEERING RACK END SUB-ASSEMBLY
Temporarily install the 2 steering rack ends to the steering rack.
Fill up the ball joints of the steering rack ends with MP grease.
Using SST, install the steering rack end (RH side) to the steering rack.
| *A | LH Side |
| *B | RH Side |
| *a | Hold |
| *b | Turn |
Rotate SST in the direction shown in the illustration.
Use a torque wrench with a fulcrum length of 400 mm (15.7 in.).
Using SST and a wrench, install the steering rack end (LH side) to the steering rack.
Rotate SST in the direction shown in the illustration.
Use a torque wrench with a fulcrum length of 400 mm (15.7 in.).
45536
2.INSTALL NO. 2 STEERING RACK BOOT
Apply silicon grease to the inside of the small opening of the boot.
Install the 2 boots to the groove on the rack housing.
45535
3.INSTALL NO. 1 STEERING RACK BOOT
Use the same procedures described for the No. 2 boot.
4.INSTALL STEERING RACK BOOT CLAMP RH
Using SST, install a new boot clamp as shown in the illustration.
3.0 mm (0.118 in.) or less
Be careful not to damage the boot.
5.INSTALL STEERING RACK BOOT CLAMP LH
Use the same procedures described for the RH side.
6.INSTALL STEERING RACK BOOT CLIP RH
Using pliers, install the boot clip.
| *a | Upward |
| *b | 180° |
|
Front of Vehicle |
Make sure that the claws of the clip are positioned within the area shown in the illustration.
7.INSTALL STEERING RACK BOOT CLIP LH
Use the same procedures described for the RH side.
44416
8.INSTALL STEERING GEAR OUTLET RETURN TUBE
Using a union nut wrench, install the return tube to the steering gear.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
9.INSTALL TURN PRESSURE TUBE
Apply steering fluid to 2 new O-rings. Using a union nut wrench, install the 2 O-rings and turn pressure tube LH.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Apply steering fluid to 2 new O-rings. Using a union nut wrench, install the 2 O-rings and turn pressure tube RH.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
45047
10.INSTALL TIE ROD END SUB-ASSEMBLY LH
Align the matchmarks of the tie rod and rack end, and temporarily install the tie rod with the lock nut.
After adjusting toe-in, tighten the lock nut.
45046
11.INSTALL TIE ROD END SUB-ASSEMBLY RH
Use the same procedures described for the LH side.