Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260968 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Sound Signal Circuit between Radio Receiver and Television Display Assembly  


DESCRIPTION

The television display assembly sends the sound signal to the radio and display receiver assembly through this circuit.

The sound signal that has been sent sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

E284346E01
6.135,0.373 6.556,0.551 0.422,0.178 10 CDL+ 5.94,0.283 6.063,0.460 0.123,0.178 10 4 6.135,0.813 6.556,0.991 0.422,0.178 10 CDL- 5.94,0.723 6.063,0.901 0.123,0.178 10 5 6.135,1.696 6.556,1.874 0.422,0.178 10 CDR- 5.94,1.606 6.063,1.783 0.123,0.178 10 3 5.792,2.446 6.214,2.624 0.422,0.178 10 H52 5.792,2.614 7.074,2.984 1.282,0.371 10 Radio and Display Receiver Assembly 0.162,2.462 0.662,2.640 0.499,0.178 10 W14 0.162,2.63 1.369,3.000 1.207,0.371 10 Television Display Assembly 0.803,0.373 1.067,0.551 0.264,0.178 10 L1+ 0.835,0.813 1.067,0.991 0.232,0.178 10 L1- 0.802,1.696 1.067,1.874 0.265,0.178 10 R1- 1.188,0.283 1.312,0.460 0.123,0.178 10 7 1.188,0.723 1.312,0.901 0.123,0.178 10 8 0.694,2.135 1.066,2.313 0.373,0.178 10 SLD1 1.188,2.044 1.398,2.222 0.210,0.178 10 11 1.188,1.606 1.398,1.783 0.210,0.178 10 10 4.26,2.298 4.911,2.476 0.651,0.178 10 Shielded 2.332,2.298 2.983,2.476 0.651,0.178 10 Shielded 6.135,1.254 6.556,1.432 0.422,0.178 10 CDR+ 0.779,1.254 1.067,1.432 0.288,0.178 10 R1+ 5.94,1.163 6.063,1.341 0.123,0.178 10 2 1.188,1.163 1.312,1.341 0.123,0.178 10 9

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
a.

Disconnect the H52 radio and display receiver assembly connector.


b.

Disconnect the W14 television display assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H52-2 (CDR+) - W14-9 (R1+) Always Below 1 Ω
H52-3 (CDR-) - W14-10 (R1-) Always Below 1 Ω
H52-4 (CDL+) - W14-7 (L1+) Always Below 1 Ω
H52-5 (CDL-) - W14-8 (L1-) Always Below 1 Ω
W14-11 (SLD1) - Body ground Always 10 kΩ or higher
H52-2 (CDR+) - Body ground Always 10 kΩ or higher
H52-3 (CDR-) - Body ground Always 10 kΩ or higher
H52-4 (CDL+) - Body ground Always 10 kΩ or higher
H52-5 (CDL-) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR