Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260969 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E280107E15
5.469,1.073 5.677,1.24 0.208,0.167 10 false 3 5.49,0.563 5.688,0.75 0.198,0.188 10 false 2 1.167,0.656 1.573,0.823 0.406,0.167 10 false UDO- 5.677,1.167 6.083,1.333 0.406,0.167 10 false UDO+ 1.656,1.083 1.865,1.25 0.208,0.167 10 false 3 1.667,0.573 1.875,0.74 0.208,0.167 10 false 2 0.552,1.573 0.917,1.74 0.365,0.167 10 false H68 0.552,1.74 1.865,2.146 1.313,0.406 10 false No. 1 Stereo Jack Adapter Assembly 5.448,1.552 5.854,1.719 0.406,0.167 10 false H69 5.448,1.719 6.646,2.125 1.198,0.406 10 false Radio and Display Receiver Assembly 5.688,0.646 6.094,0.813 0.406,0.167 10 false UDO-

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the H69 radio and display receiver assembly connector.


b.

Disconnect the H68 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H69-2 (UDO-) - H68-2 (UDO-) Always Below 1 Ω
H69-3 (UDO+) - H68-3 (UDO+) Always Below 1 Ω
H69-2 (UDO-) - Body ground Always 10 kΩ or higher
H69-3 (UDO+) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR