Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260969 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Display Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display data signal of an external device to the radio and display receiver assembly through this circuit.

WIRING DIAGRAM

E284332E03
5.677,2.292 6.083,2.5 0.406,0.208 10 false H51 5.99,0.76 6.521,0.969 0.531,0.208 10 false VV+ 5.708,0.646 5.896,0.854 0.188,0.208 10 false 13 5.99,1.333 6.521,1.542 0.531,0.208 10 false VV- 5.708,1.25 5.896,1.458 0.188,0.208 10 false 14 5.99,1.958 6.521,2.167 0.531,0.208 10 false SG 5.708,1.833 5.896,2.042 0.188,0.208 10 false 12 0.927,0.771 1.229,0.979 0.302,0.208 10 false VV+ 0.979,1.365 1.24,1.573 0.26,0.208 10 false VV- 1.333,0.667 1.521,0.875 0.188,0.208 10 false 6 1.333,1.25 1.521,1.458 0.188,0.208 10 false 11 5.677,2.469 6.99,2.885 1.313,0.417 10 false Radio and Display Receiver Assembly 0.292,2.333 0.615,2.542 0.323,0.208 10 false H68 0.281,2.531 1.594,2.948 1.313,0.417 10 false No. 1 Stereo Jack Adapter Assembly 4.135,2.083 4.854,2.271 0.719,0.188 10 false Shielded 2.292,2.083 3.01,2.271 0.719,0.188 10 false Shielded

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the H51 radio and display receiver assembly connector.


b.

Disconnect the H68 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H51-13 (VV+) - H68-6 (VV+) Always Below 1 Ω
H51-14 (VV-) - H68-11 (VV-) Always Below 1 Ω
H51-13 (VV+) - Body ground Always 10 kΩ or higher
H51-14 (VV-) - Body ground Always 10 kΩ or higher
H51-12 (SG) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR