86160C
1.INSPECT REAR SPEAKER SET
for JBL Made:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 1.8 to 2.6 Ω |
If the result is not as specified, replace the rear speaker set.
| *a | Component without harness connected
(Rear Speaker Set) |
except JBL Made:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 4 Ω |
If the result is not as specified, replace the rear speaker set.
| *a | Component without harness connected
(Rear Speaker Set) |
86160Y
2.INSPECT REAR NO. 2 SPEAKER ASSEMBLY
for JBL Made:
When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.
Malfunction disappears.
Connect the connectors to the rear No. 2 speakers.
When there is a possibility that either the right or left rear No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.
Perform the inspection above on both the LH and RH sides.