Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260975 INSTRUMENT PANEL SPEAKER G

AUDIO / VIDEO  INSTRUMENT PANEL SPEAKER  INSPECTION  


PROCEDURE

Hide 86160P 1.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY

a.

for JBL Made:

i.
E180661E16
1.624,0.189 1.820,0.359 0.196,0.170 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Always 1.6 to 2.2 Ω


If the result is not as specified, replace the front No. 2 speaker assembly.

Text in Illustration
*a Component without harness connected
(Front No. 2 Speaker Assembly)



b.

except JBL Made:

i.
E180661E16
1.624,0.189 1.820,0.359 0.196,0.170 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Always 4 Ω


If the result is not as specified, replace the front No. 2 speaker assembly.

Text in Illustration
*a Component without harness connected
(Front No. 2 Speaker Assembly)



Hide 86160P 2.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 6 Speakers)

a.

When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

OK:

Malfunction disappears.


HINT:
·

Connect the connectors to the right and left front No. 2 speaker assemblies.

·

When there is a possibility that either the right or left front No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.

·

Perform the inspection above on both the LH and RH sides.




Hide 86160L 3.INSPECT FRONT NO. 4 SPEAKER ASSEMBLY

a.

for JBL Made:

Temporarily replace the front No. 4 speaker assembly with a new or normally functioning one.

OK:

Malfunction disappears.



b.

except JBL Made:

i.
E180661E16
1.624,0.189 1.820,0.359 0.196,0.170 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Always 6 Ω


If the result is not as specified, replace the front No. 4 speaker assembly.

Text in Illustration
*a Component without harness connected
(Front No. 4 Speaker Assembly)