Home › Audio / Visual / Telematics › AUDIO / VIDEO › WINDOW GLASS ANTENNA WIRE
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260981 WINDOW GLASS ANTENNA WIRE A

AUDIO / VIDEO  WINDOW GLASS ANTENNA WIRE  REPAIR  


PROCEDURE

Hide 1.INSPECT WINDOW GLASS ANTENNA WIRE

NOTICE:
B066134E15
2.729,0.771 2.729,1.469 false 1.938,1.167 1.698,1.604 false 0.406,1.073 0.406,0.552 0.406,0.552 0.708,0.552 false 2.667,1.5 2.854,1.656 0.188,0.156 10 false *1 1.583,1.646 1.771,1.802 0.188,0.156 10 false *2 0.75,0.479 0.938,0.635 0.188,0.156 10 false *3

When cleaning the glass, use a soft, dry cloth and wipe the glass in the direction of the wire. Take care not to damage the wires. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wind a piece of tin foil around the tip of the probe and press the foil against the wire with your finger as shown in the illustration.

Text in Illustration
*1 Antenna Wire
*2 Tin Foil
*3 Tester Probe


a.
E032576

Check the voltage at the center of each wire as shown in the illustration.


Hide 2.REPAIR WINDOW GLASS ANTENNA WIRE

a.
U115515E06
2.76,1.115 2.76,1.552 false 1.74,0.906 1.74,0.583 1.74,0.583 1.958,0.365 true 0.969,0.917 0.865,1.615 0.865,1.615 1.083,1.479 false 1.979,0.229 2.146,0.396 0.167,0.167 10 false *a 2.667,1.552 2.833,1.719 0.167,0.167 10 false *1 0.698,1.563 0.865,1.729 0.167,0.167 10 false *2

Clean the broken wire tips with grease, wax and silicone remover.

Text in Illustration
*a Repair Point
*1 Antenna Wire
*2 Masking Tape


b.

Place masking tape along both sides of the wire to be repaired.


c.

Thoroughly mix the repair agent.


d.
U115517E01
1.369,0.319 1.747,0.319 false 1.443,0.925 0.736,0.925 0.736,0.925 0.532,1.096 false 0.425,1.11 0.592,1.273 0.166,0.163 10 *a 1.164,0.231 1.327,0.385 0.163,0.154 10 *1

Using a fine tip brush, apply a small amount of the repair agent to the wire.

Text in Illustration
*a Repair Point
*1 Fine Tip Brush


e.

After a few minutes, remove the masking tape.

NOTICE:

Do not allow electricity to flow in the antenna wire for at least 24 hours.