Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260988 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 55670 1.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

a.

Attach the 7 claws and 2 guides to install the No. 3 instrument panel register assembly.


Hide 86212C 2.INSTALL NO. 2 RADIO RECEIVER BRACKET

a.

Install the No. 2 radio receiver bracket with the 3 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 86211J 3.INSTALL NO. 1 RADIO RECEIVER BRACKET

a.

Install the No. 1 radio receiver bracket with the 3 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide C8215 4.INSTALL HAZARD SWITCH WIRE

a.

Attach the clamp to install the hazard switch wire.


Hide 84330 5.INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY

Hide 86120L 6.INSTALL NAVIGATION RECEIVER ASSEMBLY

a.

Connect each connector.


b.
B358816

Insert the navigation receiver assembly and attach the 7 clips on the backside of the navigation receiver assembly.

NOTICE:

When inserting the receiver, do not press the knobs on it.



c.

Install the navigation receiver assembly with the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 84010A 7.INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).