This circuit provides power to the stereo component amplifier assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the stereo component amplifier assembly connectors.
| *A | for JBL Made | *B | except JBL Made |
| *a | Front view of wire harness connector
(to Stereo Component Amplifier Assembly) |
- | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H64-2 (GND) - Body ground | Always | Below 1 Ω |
| H64-6 (GND2) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H67-3 (GND) - Body ground | Always | Below 1 Ω |
| H67-18 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H64-1 (+B) - H64-2 (GND) | Always | 11 to 14 V |
| H64-3 (+B2) - H64-2 (GND) | Always | 11 to 14 V |
| H63-12 (ACC) - H64-2 (GND) | Engine switch on (ACC) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H67-1 (+B) - H67-3 (GND) | Always | 11 to 14 V |
| H67-16 (+B2) - H67-3 (GND) | Always | 11 to 14 V |
| H63-12 (ACC) - H67-3 (GND) | Engine switch on (ACC) | 11 to 14 V |
OK
NG