Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260991 NAVIGATION SYSTEM(for Navigation Receiver Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit includes the parking brake switch assembly and navigation receiver assembly.

WIRING DIAGRAM

E280960E23
3.948,1.521 4.104,1.719 0.156,0.198 10 false 1 5.229,1.49 5.448,1.688 0.219,0.198 10 false 15 5.51,1.635 6.052,1.854 0.542,0.219 10 false PKB 5.385,2.708 5.927,2.927 0.542,0.219 10 false H56 5.406,2.896 6.688,3.25 1.281,0.354 10 false Navigation Receiver Assembly 2.885,2.188 4.25,2.542 1.365,0.354 10 false Parking Brake Switch Assembly 2.865,2 3.406,2.219 0.542,0.219 10 false G77

CAUTION / NOTICE / HINT

HINT:

When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)

b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK:
Parking Brake Condition Display
Applied ON
Released OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.




OK

NG

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
a.

Disconnect the H56 navigation receiver assembly connector.


b.

Disconnect the G77 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H56-15 (PKB) - G77-1 Always Below 1 Ω
H56-15 (PKB) - Body ground Always 10 kΩ or higher




OK

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.

Remove the parking brake switch assembly (See page Brake>PARKING BRAKE>PARKING BRAKE SWITCH>REMOVAL).


b.

Inspect the parking brake switch assembly (See page Brake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION).



OK

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY