Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260991 NAVIGATION SYSTEM(for Navigation Receiver Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  Navigation Voice Circuit  


DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.

Using this circuit, the navigation receiver assembly sends the signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E282421E04
1.175,0.611 1.573,0.795 0.399,0.184 10 SLD1 1.263,1.41 1.579,1.593 0.316,0.184 10 II1+ 1.263,2.187 1.555,2.371 0.291,0.184 10 II1- 1.64,0.508 1.827,0.695 0.187,0.187 10 18 1.626,1.292 1.813,1.480 0.187,0.187 10 15 1.612,2.119 1.799,2.306 0.187,0.187 10 14 5.389,1.312 5.563,1.485 0.173,0.173 10 2 5.372,2.107 5.552,2.259 0.180,0.152 10 6 5.61,2.205 5.962,2.394 0.352,0.189 10 RL- 5.61,1.42 5.962,1.609 0.352,0.189 10 RL+ 0.435,3.441 1.365,3.618 0.930,0.177 10 *: Shielded 3.48,2.526 4.058,2.703 0.579,0.177 10 * 0.703,2.664 1.282,2.833 0.580,0.170 10 H63 0.703,2.827 2.512,3.177 1.809,0.350 10 Stereo Component Amplifier Assembly 5.55,2.65 6.037,2.812 0.487,0.163 10 H53 5.55,2.802 6.817,3.145 1.267,0.343 10 Navigation Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the H53 navigation receiver assembly connector.


b.

Disconnect the H63 stereo component amplifier connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H63-15 (II1+) - H53-2 (RL+) Always Below 1 Ω
H63-14 (II1-) - H53-6 (RL-) Always Below 1 Ω
H63-15 (II1+) - Body ground Always 10 kΩ or higher
H63-14 (II1-) - Body ground Always 10 kΩ or higher
H63-18 (SLD1) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR