Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260992 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit includes the parking brake switch assembly and radio and display receiver assembly.

WIRING DIAGRAM

E280960E22
3.948,1.521 4.104,1.719 0.156,0.198 10 false 1 5.229,1.49 5.448,1.688 0.219,0.198 10 false 15 5.51,1.635 6.052,1.854 0.542,0.219 10 false PKB 5.208,2.677 5.75,2.896 0.542,0.219 10 false H51 5.208,2.833 6.885,3.177 1.677,0.344 10 false Radio and Display Receiver Assembly 2.885,2.188 4.25,2.542 1.365,0.354 10 false Parking Brake Switch Assembly 2.865,2 3.344,2.188 0.479,0.188 10 false G77

PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)

b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK:
Parking Brake Condition Display
Applied ON
Released OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.




OK

NG

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
a.

Disconnect the H51 radio and display receiver assembly connector.


b.

Disconnect the G77 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H51-15 (PKB) - G77-1 Always Below 1 Ω
H51-15 (PKB) - Body ground Always 10 kΩ or higher




OK

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.

Remove the parking brake switch assembly (See page Brake>PARKING BRAKE>PARKING BRAKE SWITCH>REMOVAL).


b.

Inspect the parking brake switch assembly (See page Brake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION).



OK

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY