Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260992 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Vehicle Speed Signal Circuit between Radio Receiver and Extension Module  


DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM

E261261E49
1.24,1.115 1.854,1.313 0.615,0.198 10 false SPD0 5.531,1.115 6.146,1.313 0.615,0.198 10 false SPD 1.719,0.99 2.333,1.188 0.615,0.198 10 false 2 5.323,1 5.646,1.198 0.323,0.198 10 false 5 0.5,1.948 1.115,2.146 0.615,0.198 10 false Z12 0.51,2.104 2.292,2.469 1.781,0.365 10 false Radio and Display Receiver Assembly 5.427,2 6.042,2.198 0.615,0.198 10 false Z13 5.427,2.156 6.417,2.396 0.99,0.24 10 false Navigation ECU

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the z12 radio and display receiver assembly connector.


b.

Disconnect the z13 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
z12-2 (SPDO) - z13-5 (SPD) Always Below 1 Ω
z12-2 (SPDO) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR